Belt Alpha New Material

PRODUCTS

BA01 Webbing Sling

BA02 Round Sling

BA03 Ratchet Tie Down

BA04 Endless Sling

BA05 Trailer belt

BA06 Polyester Webbing

WBRTD25

WBRTD38

WBRTD50

About Us

BELT ALPHA NEW MATERIAL

Wuxi Belt Alpha New Material Co., Ltd. was established in July 2019 and is a member firm of Shanghai Solead Group. Relying on the raw material and channel advantages of group member enterprises, we are committed to the research and development, production, and sales of flat slings, round slings, binding belts, and traction belts.

2019

Since

23000 ㎡

Area Covered

20 +

Exporting Countries

800 tons+

Monthly Output

30 +

Technical Staff

HONOR

Bion New Materials has passed the certification of ISO9001:2008 Quality Management System, GB/T24001-2004 Environmental Management System, GB/T28001-2001 Occupational Health and Safety Management System, and the measurement assurance system, which are strictly implemented.

NEWS

What are the colors of various tonnage of lifting belts

1 ton purple, 2 tons green, 3 tons yellow, 4 tons gray, 5 tons red, 6 tons brown, 8 tons blue, 10 tons and 12 tons orange. It is generally made of high strength polyester filament, which has multiple advantages such as high strength, abrasion resistance, oxidation resistance, UV resistance, etc. At the same time, it is soft, non-conductive, non corrosive (no harm to human body), and is widely used in various fields. There is one color of the sling that is not mentioned above, that is, the white sling. This is because the raw materials of white sling and color sling are different, so tonnage cannot be distinguished by color. The use of lifting belts is related to the success and failure of a single lifting operation, and is more related to the personal safety of cranes and drivers.

What are the points of lifting operation with lifting belt?

In case of severe weather such as heavy rain, heavy snow, heavy fog and wind force above 6 (including 6), outdoor hoisting operation must be stopped. It is forbidden to work under or on one side of the live high-voltage line. Overload is strictly prohibited. During the operation of two lifting belts, the two lifting belts shall be directly hung into the double hooks. The lifting belts shall be hung at the symmetrical stress center of double hooks; When four lifting belts are used, every two lifting belts shall be directly hung into the double hooks. Note that the lifting belts in the hooks shall not overlap and squeeze each other. The lifting belts shall be symmetrical to the force center of the hooks. When using the lifting belt, hang the lifting belt directly to the force center of the hook, not to the hook tip. During the hoisting operation, the lifting belts are not allowed to be crossed, twisted, knotted or twisted. The correct special connectors for the lifting belts should be used for connection. When encountering goods with sharp corners and edges, the sling must be protected by sheathing, angle protection and other methods to extend the service life of the sling. The use of slings on rough surfaces is strictly prohibited. To prevent the sling from being cut off by corners and scratched by rough surfaces. Double turn chokes are more secure. When using the sling, because the bending part of the hook makes the flat sling unable to carry evenly in the width direction, it is affected by the inner diameter of the hook. If the hook diameter is too small and it is not fully connected with the webbing eye, the correct connector shall be used for connection. The correct hoisting method shall be adopted when hoisting pipe objects. Excessive hoisting angle will cause potential safety hazards. Do not press articles on the lifting belt, which will cause damage to the lifting belt. Do not try to pull the lifting belt out from below, which may cause danger. Use objects to pad up and leave enough space for the lifting belt to be taken out smoothly. The lifting belt shall not be dragged on the ground or rough surface. After use, the sling shall be suspended for storage.